Cleanup after inlay, and final blank sizing

From Monkey Wiki, a guide to snowboard construction
Revision as of 15:08, 10 July 2011 by Head Monkey (Talk | contribs)

Jump to: navigation, search

After the glue has dried, the core blank has to be cleaned up quite a bit: the excess glue must be scraped away, and the blank has to be smoothed completely on both sides in a planer. In order to get a good first pass out of the planer, any high spots on the ash and PTEX need to be shaved down by hand with a block plane. Once the blank is done in the planer then the base side is pretty much finished. No further smoothing is done on it, and it must be perfectly flat. I take great care to keep the planer in good working order, and to make sure the final passes on the base side are light.

I love the way our blanks look at this stage. They’re perfectly smooth, and the PTEX and 2cm ash along the effective edge is perfectly smooth. It’s usually at this point that I get sad that the beauty of these cores is obscured in the final product.

After this step, the blank is still thicker than the final thickness of the board. The thickness profile will be applied by the CNC machine in a later step.

The planer is a JET 15” planer, which is wide enough to accommodate the width of a snowboard core blank.

[[Category:Not Ready]